top of page

Berto IOT Generic

 

The Berto IOT Generic driver allows connection of IOT Relay and Sensor devices. Messaging to and from the device is managed by the Berto IOT Gateway. If the device has a custom webview user interface then this can be connected to a Berto WebView driver, from connections, which provides a UI button that can be used to access the webview from a T3 touchscreen.

The Berto IOT Gateway needs to be installed in your project.

 

Properties

  • Device - The selected IOT device to be used by the driver.

  • Address - IP Address of device.

  • Model - Model of device.

  • Manufacturer - Manufacturer of device.

  • MAC Address - MAC Address device.

  • Firmware - Firmware version installed on the device.

  • Relay 1-8 - Current state of relay.

  • Input 1-8 - Current state of input switch.

  • Power 1-8 - Current power reading.

  • Voltage 1-8 - Current voltage reading.

  • Button 1-8 - Current contact state.**

  • Contact 1-8 - Current contact state.

  • Battery - Current battery level.

  • Temperature - Current temperature reading.

  • Humidity - Current humidity reading.

  • Flood - Current flood indicator.

  • Tilt - Current tilt reading.

  • Vibration - Current vibration reading.

  • Luminance - Current luminance level.

 

Connections

 

The driver creates the required standard relay and sensor connections.

Release Notes

v1.00 - 2020-06-05

  • Initial Release.

bottom of page